What material should I use for smoke stack

Tips and tricks for everything related to finishing your smoker.
Post Reply
SmokeyTheMeat
Newbie
Newbie
Posts: 2
Joined: February 9th, 2020, 8:22 am

What material should I use for smoke stack

Post by SmokeyTheMeat » February 9th, 2020, 4:03 pm

Hi, first time builder here. Learning to weld and fabricate in one shot. Turning an old air compressor in to a reverse flow smoker. I need something 4", is tailpipe weldable. Any suggestions would be apprrciated


Top
User avatar
mp4
Expert
Expert
Posts: 1259
Joined: September 2nd, 2014, 6:28 pm
Title: Independent Thinker
BBQ Comp Team Name: Just a few backyard for fun competitions.
Location: Central Wisconsin

Re: What material should I use for smoke stack

Post by mp4 » February 9th, 2020, 8:28 pm

Tailpipe is good -


Top
User avatar
Big T
Moderator
Moderator
Posts: 6478
Joined: September 1st, 2013, 2:40 pm
Title: Go Getter
BBQ Comp Team Name: Backyard Boys
Location: Lower Alabama

Re: What material should I use for smoke stack

Post by Big T » February 9th, 2020, 9:54 pm

:yth:


Measure Twice.....Cut Three Times.
Top
SmokeyTheMeat
Newbie
Newbie
Posts: 2
Joined: February 9th, 2020, 8:22 am

Re: What material should I use for smoke stack

Post by SmokeyTheMeat » February 10th, 2020, 5:33 pm

Great, thank you


Top
Post Reply

Return to “Fabrication How to's”