Thanks Chris



Sent from my iPhone using Tapatalk
Big T wrote:There's a pit calculator at the top of the forums. You start by putting the dimensions of the CC and then play with the size of the FB until you get it in the 105%-115% range and it will give you your throat size. The throat is the same for any offset or RF.
Dirtytires wrote:If you are going to insulate the firebox, I don’t see a need to make it removable. Just weld it.
Rodcrafter wrote:Looking good
Sent from my iPhone using Tapatalk
Big T wrote:It is best for them to be flush. It cuts down on turbulence from the FB to the CC.
cjohnson28 wrote:I see everyone moving the exhaust below the grate level now. The length the calc gives is that above the CC?
Sent from my iPhone using Tapatalk
Dirtytires wrote:cjohnson28 wrote:I see everyone moving the exhaust below the grate level now. The length the calc gives is that above the CC?
Sent from my iPhone using Tapatalk
Keep the exhaust at the top. I’ve had both ways and much better at top. Low mounted exhaust just let stale smoke build up and drop all the soot on my meat.
Users browsing this forum: No registered users and 1 guest